SGS OWNER`S MANUAL WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property d
SGS GAS STOVES 9 Terminal Vent Location Your SGS stove vents through a vent terminal installed on the roof or on the outside of any exterior wall of
SGS GAS STOVES 10 Installation of Drolet Wall Venting Kits Direct And Corner Vent Kit Installation AC02000: Coaxial 4" X 6 5/8" rigid vent
SGS GAS STOVES 11 Direct Vent Kit for Basement Installation AC02010: Coaxial 4" X 6 5/8" rigid vent system with black finish includes : 1-
SGS GAS STOVES 12 Vented Gas Stove Installation ("B-Vent") Instead of using a standard B-vent pipe it is possible to use a 4" flexibl
SGS GAS STOVES 13 Stove conversion for a "B-Vent" installation only The following instructions are not for a direct vent installation. You
SGS GAS STOVES 14 5. Remove and discard the metallic plate (6) from the rear heat shield using a screw driver. Unscrew just a little bit the two sc
SGS GAS STOVES 15 Gas Piping • Route a 3/8" minimum NPT iron pipe gas line to the desired location. • Install a shutoff valve to the gas line.
SGS GAS STOVES 16 Ember Kit InstallationCAUTION: Blocking gas ports with rock wool will result in poor light-up performance, delayed ignition, affect
SGS GAS STOVES 17 OPERATING YOUR STOVE For your safety ATTENTION : • A QUALIFIED INSTALLER MUST PERFORM INSTALLATION OF THE APPLIANCE, VENTING, PIP
SGS GAS STOVES 18 Shut down Instructions To turn the burner OFF but leave the pilot open • Push in and rotate the gas control knob clockwise 3 to &q
SGS GAS STOVES 1 TABLE OF CONTENTS GENERAL INFORMATION...
SGS GAS STOVES 19 The benefits of installing a blower A blower can be installed at the back of your DROLET stove. This option is necessary if you wi
SGS GAS STOVES 20 Optional Thermodisc (AC05530) Follow the installation instructions included with the optional thermodisc. The fixation holes are l
SGS GAS STOVES 21 MAINTENANCE INSTRUCTIONS WARNINGS : • TURN OFF THE GAS WITH THE SHUTDOWN VALVE AND DISCONNECT THE ELECTRICAL POWER BEFORE SERVICIN
SGS GAS STOVES 22 Burner Removing the Burner • Open the glass door. Remove the burner contour (2) and the deflector (3). Unscrew the two screws on
SGS GAS STOVES 23 OPTIONS DESCRIPTION PART #Millivolt Wall Thermostat AC05558 Tangential blower with variable speed control AC02050 Direct Vent
SGS GAS STOVES 24 1700, rue Léon-Harmel, Québec (Québec) G1N 4R9 tel. : (418) 527-3060 fax : (418) 527-4311 e-mail : [email protected] web site :
SGS GAS STOVES 2 GENERAL INFORMATION The SGS GAS STOVE is a high-efficiency gas appliance with a maximum input rating of 28 500 BTU/h (8,4 kW) with
SGS GAS STOVES 3 TECHNICAL SPECIFICATIONS SGS Dimensions TOP VIEW Dimensions Height : 27 3/4 po / 706 mm Width : 24 1/2 po / 621 mm Dept
SGS GAS STOVES 4 SGS II Dimensions Dimensions Height : 27 3/4 po / 706 mm Width : 24 1/2 po / 621 mm Depth : 23 po / 585 mm Ceramic Glass F
SGS GAS STOVES 5 Burner Natural Gas Propane LP Maximum Input, BTU/h (kW) minimum : maximum : 19 000 (5,6) 28 500 (8,4) 20 000 (5,9) 26
SGS GAS STOVES 6 INSTALLATION Before starting any installation, make sure you know : • Where you run your gas line ; • What type of venting kit yo
SGS GAS STOVES 7 Clearances to combustibles Clearance between the stove and any combustible material must also be maintained while installing your ap
SGS GAS STOVES 8 Direct Vent Installation Critical Length of Venting Pipes 0123456789101112131415161718192021222324252627282930012345678910Vertical l
Kommentare zu diesen Handbüchern